Store
sub-categories:
crimp housings
(4 products)
Install crimped wires in these to make a connector that goes on .1" headers.
heat shrink tubing
(7 products)
Use to insulate and support solder connections. Easier and neater than electrical tape.
IDC sockets (for ribbon cable)
(3 products)
These clamp onto ribbon cable and fit over double rows of .025" pins spaced .1" apart.
products in this category: (connectors, sockets, wire management)
in stock -
price: $1.90
Use these inside of plastic housing to make connectors that fit over .1" header pins. The come in a strip of 10.
in stock -
price: $12.99
Use these to install crimp pins on wires, 20-28 AWG.
in stock -
price: $4.99
Comes in 5ft segments. Peel off the number of conductors you need. Useful with IDC sockets and crimp pins to make connecting buses.
in stock -
price: $2.99
Comes in 5ft segments. Peel off the number of conductors you need. Useful with IDC sockets and crimp pins to make connecting buses.
in stock -
price: $0.25
This snaps into a 1/4" panel hole to hold standard sized LEDs (.23 diameter).
in stock -
price: $3.99
This holder attaches to any panel with a couple 4-40 screws and 1/8" holes. It has integrated holes for soldering wires.
in stock -
price: $1.29
This jack accepts standard 1/8" audio plugs, and it features a mechanical switch that can be used to tie the signal line to ground when a plug is not present.
in stock -
price: $0.15
2 pin, single row header, gold plated, RoHS Compliant.
in stock -
price: $0.49
RoHS Compliant, gold plated 40 pin break-away header.
in stock -
price: $0.79
RoHS Compliant, gold plated 80 pin break-away header.
in stock -
price: $0.15
Gold plated shunt / jumper, commonly used to select options on hardware devices like robot controllers and hard drives.
in stock -
price: $1.29
Female MIDI Connector featuring overlapping front faces for adjacent connectors.
in stock -
price: $2.49
Standard wall-wart / adaptor power jack (2.1 center, 5.5mm outside). Fits in a 5/16inch hole.
in stock -
price: $2.99
5 pin MIDI connector is easy to use and easy to mount on a panel for any MIDI required project.