Store
products in this category: (non-soldering tools and equipment)
in stock -
price: $23.99
A small, sturdy clamp that can be rotated to almost any angle to hold work or tools.
in stock -
price: $5.99
These let you trim off component leads close to the board since the cutting edges of the blades are flush with the bottom of the cutters.
in stock -
price: $3.99
A staple of any electronics work bench, these simple wire strippers / cutters can be adjusted to strip any size wire from 10-30 AWG (.5 - 4mm).
in stock -
price: $5.99
This standard prototyping bread board by Elenco features labeled rows and columns and interlocking extensions that allow multiple boards to be connected together.
in stock -
price: $8.99
350 different pre-cut and bent 22 AWG solid wires, 25 of each color and length. These make bread board prototyping substantially neater and faster.
in stock -
price: $1.99
The metal fingers on this simple tool make removing ICs easy--no wedging with small screw drivers required.
out of stock, products typically restock in less than a week -
price: $4.99
A small, heavy base with two adjustable alligator clips provides two extra "hands" when needed. It' s especially helpful when you need to hold solder in one hand, an iron in the other and wires in a third hand.
in stock -
price: $6.99
These diagonal cutters can be used to cut larger wires: up to 12 AWG soft steel or 10 AWG copper.
in stock -
price: $4.95
The pliers feature padded handles, a wire cutter, and serrated jaws.
in stock -
price: $1.99
Use this tool to grab screws that fall in hard-to-reach places like computer cases and robot bodies.
out of stock, products typically restock in less than a week -
price: $5.99
Quickly bend resistor leads to fit into pcb holes. Speeds up the build process when you have a lot of resistors to install.
in stock -
price: $4.99
6 small jeweler's screwdrivers with ergonomic rubber grips. 2 Phillips and 4 regular screw drivers.
in stock -
price: $17.15
This bread board features 1660 tie points, 8 bus lines and 3 banana jacks that can also clamp stripped wire. Rubber feet resist sliding.
in stock -
price: $5.99
This tool strips AWG 16-26, and also has a crimper and wire cutter section.
in stock -
price: $36.99
Sturdier and heavier than the Junior, the jaws can be rotated and tilted to any orientation.
in stock -
price: $11.95
Features AC and DC volt measurement, DC current up to 10A, diode and transistor test, audible continuity (beep), and square wave signal injector.
in stock -
price: $29.99
Featuring: frequency up to 10MHz, capacitance to 200uF, diode and transistor test, audible continuity test (beep), AC/DC current to 10A.
in stock -
price: $23.95
Voltage sensing and pulsing techniques enable this charger to quickly and safely charge NiMH / NiCd battery packs from 2.4V - 7.2V. A 2000mAH pack charges in about 1 hour.
in stock -
price: $14.95
Made of high quality matched NiMH 5 x AA cells with prewired female Tamiya connector.
in stock -
price: $75.99
This sturdy vise features reversible jaws that can be quickly closed and opened and a base with parts tray.
in stock -
price: $4.99
This tool has latches that let it lock closed, useful as an extra hand. Used in medicine to close off bleeding vessels, they can be used as a clamp-on heat sink in electronics.